Search for: * in Category: TRANSMISSION PARTS 37 Records Returned 10 Records Displayed. New Search

<< Previous | 1 | 2 | 3 | 4 | Next >> 1960-1965 6 CYLINDER CLUTCH KIT Category: TRANSMISSION PARTS Product ID: 07-008 Description: This is an 8 1/2 inch clutch kit designed to fit the 1960 - 1965 Ford Falcon equipped with the 144, 170 or 200 Cu. In. engine coupled to the 2.77 manual three speed transmission or Dagenham 4 speed transmission. This kit includes the clutch disc, pressure plate, throw out bearing with holder and the alignment tool. This kit Does Not include the Pilot Bushing. . Price:  $154.95 Quantity: 1963-1970 V-8 CLUTCH KIT Category: TRANSMISSION PARTS Product ID: 07-014 Description: This part is the 10 inch clutch kit for the V-8 equipped Ford Falcons. This is a diaphragm type pressure plate whereas the original was a finger type. This is the newer design. Price:  $119.95 Quantity: 1960-1965 GEAR SHIFT HANDLE INSULATOR Category: TRANSMISSION PARTS Product ID: 1M-7246-A Description: This is the rubber insulator that fits on the column mounted gear shift handle and will fit all of the 1960 - 1965 Falcons equipped with a column mounted gear shift selector. Price:  $8.00 Quantity: 1963-1965 4 SPEED SHIFT LEVER SHOULDER BOLT Category: TRANSMISSION PARTS Product ID: 379818-S Description: This is the shouldered bolt that is used to mount the 4 speed shifter handle and is sold in units of one each. Price:  $6.95 Quantity: 1960-1965 C-4 WIRING HARNESS Category: TRANSMISSION PARTS Product ID: 65-FAL-N.S.S. Description: This set of wires is used to connect the neutral safety switch on the side of the C-4 transmission to the underdash wiring harness. The set includes 2 pairs of wires, a pair of red with blue stripe for the starting system and a pair of black with red stripe for the back-up lights. Both pairs have the correct colored factory connectors. These wires are approximately 36 inches in length and include the correct rubber boot to install the wires through the floor pan. Price:  $21.95 Quantity: 1963-1965 V-8 STANDARD TRANSMISSION OUTPUT BUSHING & SEAL Category: TRANSMISSION PARTS Product ID: B3TZ-7A034SET Description:  Price:  $18.95 Quantity: 1960-1965 2.77 TRANSMISSION OUTPUT SHAFT BUSHING AND SEAL Category: TRANSMISSION PARTS Product ID: C0DP-7A034SET Description: This is the bushing and seal set for the tailshaft housing of the 2.77 3 speed manual transmission used behind the 6 cylinder engines in the 1960 - 1965 Ford Falcons. The O.D. of the bushing is 1.50 inches and the I.D. of the bushing is 1.375 inches and it is approx. 1.375 inches long. When installing the bushing, be sure to keep the oil drain hole pointed to the bottom of the housing. Price:  $27.50 Quantity: 1960-1965 2.77 TRANSMISSION TAILSHAFT HOUSING SEAL Category: TRANSMISSION PARTS Product ID: C0DR-7052-A Description: This is the seal for the rear of the tailshaft housing on the 2.77 Manual 3 speed transmission used behind the 6 cylinder engines in the 1960 - 1965 Ford Falcons. Price:  $15.95 Quantity: 1960-1964 AUTOMATIC TRANSMISSION PAN GASKET - 2 SPEED Category: TRANSMISSION PARTS Product ID: C0DZ-7191 Description: This Ford Falcon part is the transmission pan gasket for the 2 speed automatic transmission. This Ford Falcon part will fit the 1960 - 64 6 cylinder and V-8 2 speed automatic transmissions. Price:  $14.59 Quantity: 1960-1965 AUTOMATIC SHIFT LEVER Category: TRANSMISSION PARTS Product ID: C0DZ-7210 Description: This Ford Falcon part is the shift handle for the 1960 - 65 Ford Falcons equipped with an automatic transmission. It includes the rubber insulator and appropriate knob. Please be sure that the year box below reflects the year for your car when ordering. Price:  $39.95 YEAR OF CAR 1960 - 19631964 - 1965 Quantity: << Previous | 1 | 2 | 3 | 4 | Next >>

Home | Search | Current Order | Wish List